Bryant T6-PRH Manual de instrucciones descargar pdf (Pagina 12)

A07165

Fig. 5 -- Backplate Mounting

3. Drill two 3/16--in. mounting holes in wall where marked. Thermostat may

be mounted to a standard junction box, if desired. Hole pattern on ther-

mostat mounting base matches junction box mounting holes.

4. Secure rear plastic mounting base to wall with 2 screws and anchors pro-

vided. Additional mounting holes are available for more secure mounting

if needed. Make sure all wires extend through hole in mounting base.

5. Adjust length and routing of each wire to reach proper connector block

and terminal on mounting base with 1/4--in. extra wire.

6. Match and connect equipment wires to proper terminals of each connector

block, being careful not to over tighten the screws. Correct polarity must

be observed when connecting the two wires from the Equipment Control

Module to the thermostat mounting base. If wires are connected incorrect-

ly, the Display Module will not operate. See Fig. 6, 7 and 8.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 75 76

Sin comentarios

Bryant T6-PRH Manual de instrucciones Pagina 12