Bryant T2-NHP Manual de instrucciones descargar pdf (Pagina 10)

A07158

Fig. 4 -- Attach Thermostat to Backplate

11. Close thermostat assembly making sure pins on back of circuit board

align with sockets in connector.

12. Turn ON power to unit.

Whe n power is appli ed, al l display i cons are li t for 2 seconds t o te st the display .

Followi ng thi s, the equipme nt type for whic h the the r m ost at is conf igur ed is

displ a yed for an a ddi ti onal 2 sec onds . It will be one of HP, AC, H, PH, PC or C (se e

expla nat i on under Ste p 3, Opti on 01 below). A HP the rmos ta t conf i gured to opera te

an AC (se e Option 1 below ) wi l l displ ay AC. An AC thermos ta t c a nnot displ ay HP.

NOTE: If a common wire has not been connected, two AA batteries must be

used to power the thermostat.

Step 3 — Set Thermostat Configuration

Configur a ti on opti ons enabl e the insta ll er to confi gur e the thermost at for a par ti cular

inst alla ti on. Mos t are not presente d to the homeowner and the re for e must be prope rl y

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

Sin comentarios

Bryant T2-NHP Manual de instrucciones Pagina 10