Bryant TSTATBBN2S01-C Manual de instalación descargar pdf (Pagina 2)

Page 2

GENERAL INFORMATION

Storage

CAUTION: DO NOT store or install units

in corrosive environments or in locations

subject to temperature or humidity extremes

(e.g., attics, garages, rooftops, etc.). Corrosive

conditions and high temperature or humidity

can signiﬁ cantly reduce performance, reliability,

and service life. Always move units in an upright

position. Tilting units on their sides may cause

equipment damage.

Equipment should be stored in its shipping carton in a

clean, dry area. Store units in an upright position at all

times. Stack vertical units a maximum of 2 units high. DO

NOT remove equipment from shipping cartons until

equipment is required for installation.

Unit Protection

Cover units on the job site with either shipping cartons,

vinyl ﬁ lm, or an equivalent protective covering. Cap the

open ends of pipes stored on the job site. In areas where

painting, plastering, or spraying has not been completed,

all due precautions must be taken to avoid physical

damage to the units and contamination by foreign

material. Physical damage and contamination may

prevent proper start-up and may result in costly

equipment cleanup.

Examine all pipes, ﬁ ttings, and valves before installing

any of the system components. Remove any dirt or trash

found in or on these components.

Inspection

Upon receipt of the equipment, carefully check the

shipment against the bill of lading. Make sure all units

have been received. Inspect the carton or crating of

each unit, and inspect each unit for damage. Assure

the carrier makes proper notation of any shortages or

damage on all copies of the freight bill and he completes

a common carrier inspection report. Concealed damage

not discovered during unloading must be reported to the

carrier within 15 days of receipt of shipment. If not ﬁ led

within 15 days, the freight company can deny the claim

without recourse. Note: It is the responsibility of the

purchaser to ﬁ le all necessary claims with the carrier.

Notify the Customer Service of all damage within ﬁ fteen

(15) days of shipment.

Introduction

GT-X Geothermal Heat Pump units are typically

installed in a ﬂ oor level closet, basement, or in a small

mechanical room. The installation site chosen for these

units must allow adequate clearance for maintenance

and servicing of the unit without its removal from the

installation location.

Model Nomenclature

1.000"

FILTER

1.000"

SIZE:

OPTION DISCHARGE

RIGHT

LEFT

RETURN

TOP

YBV = VERTICAL UPFLOW TWIN

6V0

072

060

048

042

036

SERIES:

L = CXM W/ICM

3 = 208V, 230V/1PH/60Hz

1 = SINGLE PACK (DOMESTIC)

AIR FLOW CONFIGURATION:

REVISION LEVEL:

VOLTAGE:

3LAL

CONTROLS:

8791011

HEAT EXCHANGER OPTIONS:

PACKAGING:

5 = CURRENT REVISION

J = CUPRO-NICKEL WATER COIL, E-COATED AIR COIL

K = CUPRO-NICKEL WATER COIL,

HOT WATER GENERATOR, E-COATED AIR COIL

A = COPPER WATER COIL, E-COATED AIR COIL

B = COPPER WATER COIL,

HOT WATER GENERATOR, E-COATED AIR COIL

Rev.: 04/18/04D

1 2 3 4 5 6 7 ... 31 32

Comentarios a estos manuales

Sin comentarios

Bryant TSTATBBN2S01-C Manual de instalación Pagina 2

Comentarios a estos manuales

Relacionado con productos y manuales para Termostatos Bryant TSTATBBN2S01-C