Bryant TSTATBBN2S01-C Manual de instalación descargar pdf (Pagina 17)

Residential H&V - 60Hz R22 & R410A - Geothermal Heat Pumps - Rev.: 21 Aug, 2007D

Water

Connection End

Return Air

Remove Screws

Water

Connection End

Return Air

Rotate

Move to Side

Side Discharge

Return Air

Water

Connection End

Discharge Air

Drain

Back Discharge

Replace Screws

Water

Connection End

Supply Duct

Return Air

Water

Connection End

Drain

Return Air

Discharge Air

Side Discharge

Back Discharge

Overview

Horizontal units can be ﬁ eld converted between

side (straight) and back (end) discharge using the

instructions below.

Note: It is not possible to ﬁ eld convert return air

between left or right return models due to the

necessity of refrigeration copper piping changes.

Preparation

It is best to ﬁ eld convert the unit on the ground before

hanging. If the unit is already hung it should be taken

down for the ﬁ eld conversion.

Side to Back Discharge Conversion

Place unit in well lit area. Remove the screws as shown

in Figure 4 to free top panel and discharge panel.

2. Lift out the access panel and set aside. Lift and rotate

the discharge panel to the other position as shown,

being careful with the blower wiring.

Check blower wire routing and connections for tension

or contact with sheet metal edges. Reroute if necessary.

4. Check refrigerant tubing for contact with

other components.

5. Reinstall top panel and screws noting that the location

for some screws will have changed.

6. Manually spin the fan wheel to insure that the wheel

is not rubbing or obstructed.

7. Replace access panels.

Back to Side Discharge Conversion

If the discharge is changed from back to side, use above

instruction noting that illustrations will be reversed.

Left vs. Right Return

It is not possible to ﬁ eld convert return air between left or

right return models due to the necessity of refrigeration

copper piping changes. However, the conversion process

of side to back or back to side discharge for either right

or left return conﬁ guration is the same. In some cases,

it may be possible to rotate the entire unit 180 degrees

if the return air connection needs to be on the opposite

side. Note that rotating the unit will move the piping to the

other end of the unit.

FIELD CONVERSION OF AIR DISCHARGE

Figure 5: Right Return Side to Back

Figure 4: Left Return Side to Back

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 67 68

Comentarios a estos manuales

Sin comentarios

Bryant TSTATBBN2S01-C Manual de instalación Pagina 17

Comentarios a estos manuales

Relacionado con productos y manuales para Bombas de calor Bryant TSTATBBN2S01-C